Deluxe Motion Upgrade Kit Instructions

This document describes the steps for upgrading a Need for Speed™ Underground Deluxe Motion Cabinet to Need for Speed™ Carbon. The Upgrade Kit includes a new computer, Software, Game Dongle, Artwork, and an external mounting bracket for the Nytric USB I/O PCB. Need for Speed™ Carbon software requires a new computer. You will need to remove the Digital-Analog Converter (DAC) card and Nytric USBI/O PCB from your existing computer. Be sure to keep your Need for Speed™ Underground Operation and Service Manual for cabinet setup, service, troubleshooting, parts, and general hardware reference information. Refer to the Need for Speed™ Carbon Operation Manual from the kit for operation and game play information, including detailed information on using the Operator Menus.

Test and Clean Before Upgrade
Installing new software will not fix existing hardware problems. Refer to the checklist included in the kit, and perform the checks to make sure your cabinet is in optimal operating condition before the upgrade. Refer to Chapter 5 of your Need for Speed™ Underground Operation and Service Manual for detailed information and repair instructions.
Open Display Cabinet and Remove Computer
1. Turn off the game and disconnect both AC power cords from the back of the display cabinet.
2. Remove the rear panels and front access panel from the display cabinet.
3. Disconnect all of the cables from the back of the computer. Make sure they are labeled for easy reconnection.
4. The computer is secured in place with a U-bracket. Remove the two (2) screws at each end of the U-bracket and remove the bracket and the computer. Take the computer to a workbench.

Remove Components from Old Computer
The new computer in the kit is pre-loaded with Need for Speed™ Carbon Motion Software. You will need to remove the Digital to Analog Converter (DAC) Card and Nytric USBI/O Card from your existing computer. You will be installing the DAC Card in the new computer, and the Nytric Card in the external mounting bracket from the kit.
Note: Keep all posts and retaining screws for re-installing the components.
1. Remove the case screw and press the button on the side panel, as shown below, to remove the side panel from the computer. (Remove the side with the ventilation holes.)
2. Refer to Figure 2 and perform the following steps to remove components from the old computer:
a. Remove the retaining screw that secures the Digital-Analog Converter (DAC) card in the computer. Carefully remove the card by pulling it straight out.
b. Remove the two posts that secure the Nytric DB25 connector (on the Ribbon Cable) to the back of the case.
c. Disconnect the Power Cable from the Nytric USB I/O PCB inside the computer.
d. Remove the retaining screw that secures the Nytric PCB in the computer. Carefully remove the PCB by pulling it straight out.

source