This B&M Short Throw Shifter has been designed to work on most 2000-2001 Audi TT 1.8L Turbo models. It has been engineered to greatly reduce shift throw and improve shifter feel. The B&M Short Throw Shifter has been designed to work with the stock knob as well as the B&M Knob. Check the parts and tools lists at the beginning of these instructions for the supplied parts and the tools required to install your B&M Short Throw Shifter. Installation of the B&M Short Throw Shifter can be accomplished by anyone with minimal mechanical experience.
INTRODUCTION
This B&M Short Throw Shifter can be installed in less than 3 hours by carefully following the instructions. Read all instructions first to familiarize yourself with the parts, tools, and procedures. This kit contains all the parts necessary to install the shifter.
STEP 1. Unscrew knob a.
STEP 2. Remove eight (8) screws b.
TOOL: Torx Drive (T-20) S
STEP 3. Remove bezel c.
STEP 4. Remove rubber boot / collar assembly d
STEP 5. Seperate rubber boot d from collar.
STEP 6. Carefully raise and support vehicle.
TOOL: Jack U , Jack Stands x4 V
STEP 7. Remove heat shield snap washers e .
TOOL: Screwdriver (Flat) T
STEP 8. Loosen exhaust coupling nuts f .
TOOL: Wrench (17mm) W
STEP 9. Slide exhaust coupling g forward
STEP 10. For AWD (Quattro), disconnect catylytic converter exhaust system. Heat shield must be removed by maneuvering around the driveshaft.
source
Monday, March 29, 2010
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment