BMW E36 Eclipse Lights Installation Guide

The kit is very easy to install. Please take your time during the installation. The rings, once installed, are durable enough to take the rigors of driving. When installed the rings will resist vibration extremely well. The rings are only susceptible to breakage during installation if not careful. Do not attempt to flex, bend or put pressure on the ring itself.

The rings can shatter when broken which may result in flying glass. It is advisable to wear eye protection when handling & installation the rings. All fluorescent lamps contain small amounts of Mercury. If you break a ring do not blow the debris away or inhale the powder. Wipe up any debris with a damp paper towel. Handle the rings with care until they are installed inside of headlights and they will provide years of trouble free operation. Lamps can last for over 100,000 hours of operation. The power packs included have to be hard wired into the headlamps. Ensure you have suitable connectors or soldering equipment available before installation.

With the headlamps removed from the vehicle :.
1. Use a flat blade screwdriver, remove the 4 metal clips holding the lens assembly and back housing together. 2 clips are on the top and 2 clips on the bottom.
2. Unclip the lens assembly from the rear housing.
There are 4 clips to release, 2 on each side of the headlamp.
3. Pull the lens assembly apart from the rear housing and place on a clean surface.
Ensure that the headlamp lenses are clean and free of any dirt/dust. Clean them it if necessary.
5, Carefully place the ring into the lens cavity. Ensure the ring is seated flat against the lens.
* It may be necessary to bend the wiring on the end of the ring, If necessary please do so very carefully.
6. Use masking tape to hold the rings in position
7. The next step requires a clear Silicone based sealant/adhesive. Clear sealant/adhesives are readily available from motor factor stores.
8. Carefully apply the silicone adhesive onto the ends of the rings as shown. Remove any unwanted adhesive immediately (follow the instructions on the silicone sealant).

source