2008 Toyota Highlander EC Rearview Mirror

Steps for EC Rearview Mirror installation: 1. Remove Battery Cable. (a) Protect fender before starting. (b) Do not touch the positive terminal with any tool when removing cable. (c) Remove the negative battery cable. (Fig. 1-1) 2. Vehicle Disassembly. (a) Remove the OE mirror. (1) Disengage the two claws and remove the mirror cover from the mirror base. (Fig. 2-1) (2) Pull the lever in the direction indicated by the arrow shown in the illustration and slide the inner rear view mirror assembly upward to remove it. (Fig. 2-1) (b) Using panel removal tool remove overhead console from headliner. (Fig. 2-2) (1) Disconnect any connectors connected to the overhead console. 3. Install T-taps. (a) Locate the disconnected 22-pin overhead console connector. (Fig. 3-1) (b) Peel back or cut approximately one inch of the wire cover. (Fig. 3-2) (c) Locate the LIGHT GREEN wire in pin #9 on the 22-pin connector. (Fig. 3-3) (d) Attach T-tap connector to LIGHT GREEN wire (pin #9) on the 22-pin connector with needle-nose pliers about 1 inch from the connector. (Fig. 3-4) (1) Ensure both halves of T-tap connector are snapped together. 3. Install T-taps. (a) Locate the disconnected 22-pin overhead console connector. (Fig. 3-1) (b) Peel back or cut approximately one inch of the wire cover. (Fig. 3-2) (c) Locate the LIGHT GREEN wire in pin #9 on the 22-pin connector. (Fig. 3-3) (d) Attach T-tap connector to LIGHT GREEN wire (pin #9) on the 22-pin connector with needle-nose pliers about 1 inch from the connector. (Fig. 3-4) (1) Ensure both halves of T-tap connector are snapped together. (e) Locate the LIGHT GREEN/RED (or WHITE/BLACK) wire in pin #2 on the 22-pin connector. (Fig. 3-5) (f) Attach T-tap connector to LIGHT GREEN/RED (or WHITE/BLACK) wire (pin #2) on the 22-pin connector with needle-nose pliers about 1 inch from the connector. (Fig. 3-6) (1) Ensure both halves of T-tap connector are snapped together. 4. Install EC Mirror. (a) Slide the EC mirror onto the mounting button on windshield. (Fig. 4-1) (b) Tighten the screw in the mirror mounting bracket with torque wrench to 1.75 N-m (15.5 lbf-in). (c) Plug the EC mirror harness into the mirror. (Fig. 4-2)

Source