2003-2007 Lexus LX 470 Bracketron Phone Mount

FOR LEXUS LX470, Skip step #1 and moved to step #2 On the 2003 Toyota Land Cruiser, begin by removing the air vent and bezel on the right side of the radio using the Dash Trim tool. Insert the Dash Trim tool behind the upper right corner to release the first clip, working the remaining clips loose. Disconnect all wiring and set the bezel aside. Move to step #3
On the Lexus LX 470, use the Dash Trim Panel tool to remove the bezel that surrounds the tape player and radio. Note: See the first picture. Work the top of the bezel loose, then continue with the bottom of the bezel where there are three plas- tic clips to release. These clips can be hard to loosen so be careful. Move the bezel out of the way. Move to step #4
On the Toyota Land Cruiser, use the #2 Phillips screwdriver and remove the four (4) bolts that hold the radio in place. Set the screws aside. Set the emergency brake and shift the transmission into first gear. Lift the radio out and set it on a soft protective cloth on the console area.
Place the Custom Bezel Mount on the flat spot just below the center clip hole on the right side of the cavity. Use the hole in the mount as a guide to mark a spot for drilling a pilot hole. Set the mount aside. Use the 5/64” drill bit and hand drill to create a pilot hole. Place the mount back over the flat spot aligning the pilot hole and the hole in the mount. Insert the provided screw and tighten the mount down in place. Note: The tight fit between the bezel and the dash pad will provide additional support for the mount.
Reinstall the dash in reverse order securing all components. Install any Bracketron phone holder or Amps compatible device to your Bezel Mount. Your installation is complete.

Source