AEM Short RAM System for Acura RSX 2002-2005. The AEM Short Ram Air Intake System is the result of extensive development on a wide variety of cars. It is the most advanced short pipe air intake system on the market. Each system is specifically engineered for its application. All AEM Short Ram Air Intake Systems deliver maximum performance gains through lightweight, all-aluminum, mandrel-bent tubing that is tuned in both length and diameter. The aluminum will not crack in extended use like plastic. The tube length and diameter are matched for each specific engine to give power over a broad RPM range. Unlike plastic systems that use a continually diverging cross-section, we take advantage of the acoustical energy in the inlet duct to promote cylinder filling during the intake valve-opening event. Every intake is coated with a high-gloss, heat-reducing Zirconia based powder coating. This special blend of powder coating helps reduce heat penetration, which in turn reduces the temperature of the inlet air charge.
Note: This inlet pipe kit requires the removal and reinstallation of emissions related components. If you are not familiar with the installation and/or the operation of these components then please refer this installation to a qualified professional.
1) Getting started a) Make sure vehicle is parked on a level surface. b) Set parking brake. c) Disconnect negative battery terminal. d) If engine has run within the past two hours let it cool down.
2) Removing the stock air inlet system a) Loosen the two 10 mm bolts and removethe injector cover. b) Loosen the two hose clamps securing the stock intake tube to the throttle body and filter box. Unplug the intake air temp (IAT) sensor, and remove the stock intake tube. Remove the intake air bypass thermal valve vacuum hose.
Source
Wednesday, June 23, 2010
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment