Transponder Bypass for Honda ET Acura (2 programmable modes)

You must use the Black key to complete the programming procedure. Programming : Keep the programming button pressed down while inserting the wire harness into connector of the HONDA-DA. Release the programming button once the LED turn ON. Turn the Ignition to the ON position. The number of LED flashes indicates the mode. (I.e. Mode 1 = 1 Flash) Press the programming button to switch between modes 1, 2 and 3. (Mode 3 is future use) Once the mode is selected, turn the ignition key to OFF position. Turn the IGNITION key to the ON position once again. The LED will illuminate. The module is now programmed. Turn the key to the OFF position and remove it, start the vehicle using the remote starter to insure functionality.
Troubleshoot: With Ignition key ON : LED flashing rapidly : Module already programmed and not actived by Ground IN. LED OFF : Module not programmed. With remote starter ON : LED steady ON : Module functional in mode 1, with the remote starter Ground IN. LED OFF: Module functional in mode 2, with the remote starter Ground IN.
Note: Neither the manufacturer or distributor of this module is responsable of damages of any kind indirectly or directly caused by this module, except for the replacement of this module in case of manufacturing defects.

Source