This manual is intended for the installation of Powerdyne Supercharger kit, Part Number K10525 on Chevrolet and GMC S-10/15 Pickup and SUV’s with the 4.3 liter Vortec motor, model years 1996-1999. This kit is designed to be 50 state smog legal and as of the writing of this manual C.A.R.B. (California Air Resources Board) exemption is pending. This kit already complies with EPA memorandum 1A, making it smog legal in 49 states providing your states pollution laws do not supercede EPA memorandum 1A.
It is very important that these instructions be followed exactly. Premium unleaded fuel with an octane rating of 92 or higher must be used with this Supercharger installed at all times. Failure to use the proper fuel may cause detonation (pinging) and cause severe engine damage. Never change the crank Pulley or the Supercharger Pulley as this will void the factory warranty (see warranty document on the preceding page) and may cause severe engine damage.
Component Removal:
A. Disconect battery cables from battery.
B. Remove fan shroud and fan.
C. Remove entire air inlet Assy. including the filter box and the IAT sensor.
D. Remove vent tube from right side valve cover.
E. Remove accessory drive belt.
F. Remove the tensioner from the alternator mounting bracket.
G. Remove the alternator and it’s mounting bracket.
H. Remove 3/8” stud form right side cylinder head.
I. Drain about 1 gallon of fluid from radiator.
J. Remove the rubber heater hoses that run from the heater core to the water pump and intake manifold
source
Monday, June 28, 2010
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment