Step 1: vehicle preparation
Location: driver’s side engine compartment.
1. Disconnect negative side of battery (as illustrated in hints). Remove the plastic cover over positive terminal and disconnect positive side of the battery. Figure 6
2. Remove (2) two 10mm bolts securing fuse box and (1) one 10mm bolt securing power steering fluid reservioir to battery tray. Figure 6
3. Loosen (2) two 10mm nuts retaining the battery placement bar and remove. Remove battery. Remove (4) 12mm bolts from battery tray and remove tray from vehicle. Figure 7
Step 2: wire harness routing
1. Place cruise control module assembly in the approximate location for mounting (two threaded holes of battery tray) and route cable and harness toward firewall. Figure 8
2. Remove (2) two 10mm nuts securing the radiator surge tank and pull away from firewall to access firewall grommet located behind it. Figure 9
3. Route cruise control harness toward firewall access hole along factory vehicle harness. For abs equipped vehicle, route cruise control module harness harness beneath brake pressure module along factory wiring harness.
source
Wednesday, June 2, 2010
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment