Installation Preparation 1. Inspect electrochromic mirror for damage or defects. 2. Verify with parts list. 3. Place parts on a clean, padded surface. 4. If the vehicle is equipped with an antitheft radio, the security code must be recorded prior to disconnecting the battery cable. The code should be reentered after reconnecting the negative battery terminal. 5. Disconnect battery negative terminal from battery and isolate cable. 6. Remove driver’s side A-pillar garnish. OPTIONAL STEP 7. Remove lower dash panel. OPTIONAL STEP 8. Remove the driver’s cover side trim / fuse block cover. OPTIONAL STEP 9. Store all removed parts on a clean, padded surface. 10. Remove & discard original equipment (OEM) rearview mirror.
Temperature Probe Installation
1. Install temperature probe on to lower left front bumper. • Attach probe behind bumper by sliding s-clip over bumper support as shown. (Figure 1) • Probe should be 90° from vehicle direction (tip of probe facing drivers side) 2. Route the probe wires from the front bumper area, up through the driver’s side of the engine compartment to the main wire harness grommet. 3. Tie wrap wires in engine compartment on drivers side as shown.
Source
Wednesday, June 2, 2010
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment