1996-2002 Dodge Viper GTS Cat-Back Exhaust System

This Borla Performance Cat-Back™ Exhaust System (Part number 14663) has been designed for the 1996-2002 Dodge Viper GTS. Borla Performance Industries recommends that an exhaust shop or professional after market parts installer, who has all the necessary equipment, tools and experienced personnel needed for proper installation, should perform the installation of this system. However, if you decide to perform the installation, we recommend someone should help you. Ensure the installer uses all under car safety precautions including eye protection.
Note: With a used vehicle, we suggest a penetrating spray lubricant to be applied liberally to all exhaust fasteners and allowing a significant period of time for the chemical to lubricate the threads before attempting to disassemble.
1. Disconnect battery by removing the negative (-) cable from the battery terminal first. 2. Remove the four bolts at the rear of the vehicle securing the rubber brackets. 3. Remove the rear clamps located at the rear of the vehicle at the slip fit connection that separates the front and rear sections of the exhaust system. 4. Using a rubber mallet, remove the rear section of the exhaust system by striking it at the slip fit, hitting toward the rear of the vehicle. 5. Applying a sparing amount of spray lubricant, remove the rubber brackets from the stock exhaust system and place them aside for use on the new Borla Performance Cat-Back™ system. 6. Remove the fiberglass skirts from under each door by removing the six screws on top and four screws on the bottom of each skirt. 7. Remove both oxygen sensors from the center pipes located just in front and inside of each rear tire. 8. On both sides of the vehicle, loosen the clamp that is located between the catalytic converter and the muffler and slide the clamps onto the catalytic converter pipe.

Source