1999-2000 Toyota Camry Radio Replacement

The plastic dash panel surrounding the radio and air conditioner controls must be unsnapped from the dash in order to gain access to the bolts which secure the radio. Pull out the ashtray at the bottom of the plastic dash panel. With your hands, grab the bottom of the plastic dash panel below the ashtray location and pull firmly until the plastic dash panel begins to unsnap from the dash. Continue to pull the dash until the sides and top of the dash panel completely unsnap from the main dash assembly. The radio is secured to the dash with four (4) 10 mm bolt screws, (1) at each side corner of the radio. Locate and remove all four bolt screws. Pull the radio out of the dash. Unplug the black cable plugged into the rear of the radio. Unplug (2) white plastic wire harness connectors snapped into the rear of the radio. The radio can now be completely removed from the dash.
Mounting The Radio
Move to: Mounting New Radio Section
The Install Doctor STRONGLY recommends purchasing a ‘DIN’ radio for this vehicle. ‘DIN’ radios are a direct replacement for the radio in this vehicle. More information is available in the “Mounting New Radio” section.
Completing The Radio Installation
Oversized 2x ‘DIN’ Toyota radio without a pocket
Standard Toyota radio with pocket/tray below radio
New radio mounted to the Toyota brackets and pocket below the radio
STEP 1: The radio is secured to the brackets of the radio/pocket assembly with four (4) phillips screws / 8mm bolts, 2 on each side of the radio. Remove all 4 screws and pull the radio out of the brackets.
STEP 2: The new replacement radio can be inserted into the brackets in the same location that the auto makers factory radio was mounted.
NOTE: notice that the face of the radio is flush or level with the pocket below it. This is important to remember when mounting the new radio in latter steps.

Source