Prior to starting the installation, remove the 2 plastic clips inside of the grill. This is an illustration to show you how to remove the front bumper. Start by removing all plastic clips and screws as shown above, once all clips and screws have been removed continue to pull the front bumper off. The two plastic clips are removed from side of the wheel well prior to pulling the bumper off. Once all plastic clips and screws have been removed, continue to pull off the bumper. Depress the tab and pull the electrical harness connector from the mass air flow sensor. The harness clip is pulled out from the air box attachment as shown above. The stock screws are loosened and removed from the mass air flow sensor. The mass air flow sensor is now pulled out of the sensor housing. The crank case hose is removed from the air duct vacuum port. The air duct clamp is loosened at the throttle body, once the clamp has been loosened the air duct is ready to be pulled off. The metal clip holding the upper air box to the lower air box is unhooked from the top box. The second metal clamp is unhooked from the upper air box. The upper air box is detached from the lower air box and air intake duct is removed from the throttle body. The stock filter panel is removed from the lower air box. The three m10 bolts are loosened and removed from the lower air box as shown above. The lower harness brace is removed from the lower air box stand-off.
Source
Tuesday, August 10, 2010
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment