All instructions assume a drivers seat vantage point. Caution is advised when removing and reassembling wood or plastic parts of a dash. Applying unnecessary force or pressure may cause a piece to crack or break. Pro.Fit logo and part number will be right side up and readable when installed.
TOOLS REQUIRED: #2 Phillips screwdriver, hook tool.
PARTS INCLUDED: Pro.Fit VSMTM, instructions.
LOCATION: To the right of the radio.
STEP 1.Begin by removing the trim bezel surrounding the radio. To do this, insert hook tool between the console dash and the trim bezel at the bottom right and left corners. Bezel will release. Do not disconnect cigarette lighter wiring harness. Lay trim bezel to side.
STEP 2. Remove the radio mounting screw on the right side of radio. Attach the phone hang-up cup onto Pro.Fit VSMTM.
STEP 3. Position Pro.Fit VSMTM over centering pin and screw hole. Insert and tighten factory screw.
STEP 4. Reinstall radio trim bezel back into position. This completes the installation of your Pro.Fit VSMTM.
Source
Monday, August 23, 2010
1992-96 Toyota Camry Pro.Fit Part Number TY-50-92 Installation Instructions
8:11 PM by onesecond
·
Labels: bezel, camry, cigarette, drivers seat, hook tool, phillips screwdriver, point caution, pro fit, radio, screw hole, side step, step 3, Toyota, toyota camry, ty, unnecessary force, vantage point, wiring harness
Labels: bezel, camry, cigarette, drivers seat, hook tool, phillips screwdriver, point caution, pro fit, radio, screw hole, side step, step 3, Toyota, toyota camry, ty, unnecessary force, vantage point, wiring harness
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment