Exhaust System Installation For 2007 Toyota Camry LE/SE/XLE

Original Exhaust System Removal
Note: With a used vehicle, we suggest a penetrating spray lubricant to be applied liberally to all exhaust fasteners and allowing a significant period of time for the chemical to lubricate the threads before attempting to disassemble.
1. Unbolt the flanges shown in figure 1 located just in front of the muffler assemblies. Place the nuts to the side for use during the installation of your new exhaust.
2. Lubricate all the hangers and rubber isolators.
3. Using a muffler stand or an additional person to hold the right muffler assembly in place, remove the hangers from the rubber isolators and then remove muffler as shown in figure 2.
4. Repeat step 3 for the removal of the left side muffler assembly.
Borla Performance Rear Section Exhaust System Installation
1. Using the bolts provided and the original nuts, place the right muffler assembly into position as shown in figure 3 making sure to install the hangers into the rubber isolators. Hand tighten the hardware for now.
2. Using the original nuts, place the left muffler assembly into position as shown in figure 4 making sure to install the hangers into the rubber isolators. Hand tighten the hardware for now.
3. Check your exhaust system for proper clearance under the vehicle and also for tip alignment.
4. Once position has been determined to be correct, tighten the flange hardware to 22-25 ft. lbs.
5. Before starting your vehicle, make sure to check all wires, hoses, brake lines, body parts and tires for safe clearance from the exhaust system.
6. Start vehicle and check for any leaks. If any leaks are found, determine cause (such as loose hardware) and repair as necessary.

Source