06-UP BMW E90-E93 Rear Camber Link Kit Installation

Installation of Rear Camber Links
1. Raise vehicle and support with jack stands. Remove rear wheels. Place jacks under the rear lower control arms, and jack up slightly to take load of the upper control arms.
2. Remove the ABS wire retaining clip from the upper control arm.
3. Remove the bolts that attach the upper control arms to the knuckle and to the sub-frame, and remove the control arms.
4. Place the factory control arms next to the new double adjustable control arms. Adjust the new arms to the same length as the factory arms as a starting point for the alignment.
5. Install the new arms into the car. The shorter arm goes towards the front of the vehicle. Note that one rod end spacer on each arm has a tapered end. Make sure to install the tapered end against the suspension upright.
6. Tighten all of the control arm bolts, and use the supplied zip-tie to attach the ABS line to the upper control arm.
7. Make sure all the nuts & bolts are fully tightened. An alignment must be performed after installation is complete.

Download