Remote Starter Integration for the 2007 Toyota Camry equipped with the Smart Key System with Push Button Start

Preparation the Toyota Camry for installation
-Remove the driver’s side under dash, as well as the knee airbag bolts. Move the Airbag aside, but DO NOT DISCONNECT the Airbag connector in order to avoid setting any vehicle codes.
-Remove the driver’s side floor heating duct, in order to access the vehicle IMI & IMO wires easily.
The remote car starter will be installed in a conventional manner even if the car is equipped with the Smart Key “Push-to-Start” system.
Main Ignition Harness Connection:
Most of the connections will be done behind the Fuse box. This fuse box is located under the driver side underdash.
Also, the vehicle’s TACH wire can be found inside vehicle, as per diagram below and it is suggested to use this wire for the remote start tach source. The remote start hood pin switch wire is the only wire which must be run into the engine compartment for safety.
Wiring Location for the Bypass Kit XK-05 PKT-2:
The connection for the XK05-PKT2 will be done on the driver side under dash. The wires required are from a 5 wires harness coming from behind the heater module, high above the gas pedal near the firewall. The five wires in this harness are as follows:
Blue: transponder IMI (Immobilizer in) wire, which gets cut in two and wired in series. The bottom-half wire connects to the kits Violet/White wire and the top-half wire connects the kits Violet wire.
Green: transponder IMO (Immobilizer out) wire, which gets wired in parallel with the kits Orange wire.
White/Black, White & Orange…these wire are not used for installation
The GREEN LED output wire from the XK05-PKT2 is not required for this installation. The vehicle LED does come on during remote start.

Source