If multiple relays or devices are connected to the Ground Out When Running wire of the remote starter, ensure they are all diode isolated in order to avoid feedback and damaging the vehicle. Do not connect to the GOWR in the back of the remote starter when using multiple device or relays.
This section refers to the Illustration 1 wiring diagram
1- Wire the GM-T100 as indicated on the wiring schematic.
2- Before connecting the harness to the GM-T100, place the jumpers to the programming positions indicated on figures A, C or E.
3- Connect the harness to the GM-T100.
4- Start the engine with the key.
5- When the LED flashes 4 times, the GM-T100 is programmed.
6- Place the jumpers to their respective operating position.
NOTE: Under no circumstances shall the manufacturer and distributors of the parts (GM-T100) be liable for consequential damages sustained in connection with the parts (GM-T100) neither assume nor authorise any representative or other person to assume for it any obligation or liability other than the replacement of the parts (GM-T100) itself.
source
Wednesday, June 9, 2010
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment