Prepare for the installation. • If possible, install the SWI-X while you are installing the new head unit. Keep in mind you may need to plug in the factory stereo to locate certain wires; therefore do not complete the head unit installation until the SWI-X is working properly. • Plan a general installation location for both the SWI-X LED and the control body. Keep in mind that the supplied wire harness is two feet long, and the IR harness is four feet long. • Use a multimeter or approved measuring device for checking vehicle circuits.
Step 1. Connect the BLACK wire to ground (-). Verification: Wire or location registers a constant (-) when probed. Step 2. Connect the RED wire to switched +12V. Verification: Wire registers +12V when the ignition key is turned to the ACC or ON positions. Step 3. Connect the appropriate interface wire (WHITE, YELLOW, ORANGE or GREEN). • Refer to the Appendix E - Identification and Connection Chart (pages 6-7). Locate the vehicle and note the SWC wire color in the “Interface Wire Color” column. • Note the vehicle wire color and location information in the “Identification” column. Note: You will only connect ONE of these wires. Cut and insulate the unused wires. • Connect the wire as indicated.
Source
Friday, June 18, 2010
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment