2005+ Toyota Tacoma Service Guide & Vehicle History

Remote Keyless Entry Reprogramming The vehicle should meet the following conditions before proceeding; *The key is NOT in the ignition *Driver’s door is OPEN (The others are CLOSED) *Drivers door UNLOCKED 1) INSERT & REMOVE key from ignition cylinder TWICE within 5sec 2) CLOSE and OPEN the driver’s door TWICE within 40sec 3) INSERT and REMOVE the key into the ignition cylinder 4) CLOSE and OPEN the driver’s door TWICE within 40 seconds 5) INSERT the key in the ignition and CLOSE the driver’s door 6) Turn the ignition switch from LOCK to ON and back to LOCK at 1sec Intervals "2" times to enter REWRITE MODE 7) REMOVE the key from the ignition (The door locks are cycled LOCK-UNLOCK within 3 seconds TWICE to let you know that you have selected REWRITE MODE) 8) Within 40 seconds press BOTH the LOCK & UNLOCK buttons on the transmitter simultaneously for 1 second (Press and release). 9) Within 3 seconds press and release the LOCK button on the same transmitter (The door locks will cycle ONCE if the transmitter was recognized and TWICE if it was not recognized {if you get two cycles start over}). 10) Within 40 seconds repeat step 8 and 9 with any other transmitters you wish to program 11) One of the following will END the Rewrite mode; *40 seconds elapses *Drivers door is opened *Key inserted into the ignition cylinder *4 transmitters are registered
Reset The MAINT REQ Light (5000mi Interval) 1) With the truck off or key at ACC, hold the odometer button down. 2) Insert key and turn to ON/RUN position (not START), continue holding the odometer button down. Odometer will flash and then display all zeros indicating the MAINT REQ light is reset. 3) Release odometer button and turn key to OFF position.

Source