Before removing the original exhaust system from your vehicle, please compare the parts you have received with the bill of materials provided on the previous page to assure that you have all the parts necessary for the installation of your new Borla Performance Cat-Back ™ Exhaust System.
Original Exhaust System Removal
Note: With a used vehicle, we suggest a penetrating spray lubricant to be applied liberally to all exhaust fasteners and allowing a significant period of time for the chemical to lubricate the threads before attempting to disassemble.
1. Carefully disconnect and remove the oxygen sensors located just behind each front flange as the left side shown in figure 1. Place them to the side for use during the installation of your new exhaust system.
2. Unbolt and remove the center support bar shown in figure 2. Place the hardware to the side for use during the installation of your new exhaust system.
3. Unbolt the flanges shown in figure 3. Place the hardware to the side for use during the installation of your new exhaust system.
4. Lubricate all the hangers and rubber isolators.
source
Saturday, June 5, 2010
2005-2006 Cadillac STS Exhaust System Installation
9:45 PM by onesecond
·
Labels: 2006 cadillac sts, bill of materials, Cadillac, cadillac sts, cat back exhaust, exhaust system, fasteners, figure 1, figure 3, flange, flanges, hangers, oxygen sensors, penetrating spray, performance cat, period of time, rubber isolators, spray lubricant, system 3, threads
Labels: 2006 cadillac sts, bill of materials, Cadillac, cadillac sts, cat back exhaust, exhaust system, fasteners, figure 1, figure 3, flange, flanges, hangers, oxygen sensors, penetrating spray, performance cat, period of time, rubber isolators, spray lubricant, system 3, threads
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment