Precision manufactured using aircraft quality T-304 stainless steel; this system is designed to endure years of heavy use. Installing a Borla Performance Exhaust System on your vehicle will eliminate the restrictive design of the stock exhaust, allowing your engine to discharge exhaust gas easier. The result is more horsepower and torque, longer engine life, and a distinctive throaty growl- all this, with easy bolt-on installation. These installation instructions have been written to help you in the installation of your Borla Performance Exhaust System. Please read it completely before installing your system.
Original Exhaust System Removal
Note: With a used vehicle, we suggest a penetrating spray lubricant to be applied liberally to all exhaust fasteners and allowing a significant period of time for the chemical to lubricate the threads before attempting to disassemble.
1. Carefully disconnect and remove the oxygen sensors located just behind each front flange as the left side shown in figure 1. Place them to the side for use during the installation of your new exhaust system.
2. Unbolt and remove the center support bar shown in figure 2. Place the hardware to the side for use during the installation of your new exhaust system.
3. Unbolt the flanges shown in figure 3. Place the hardware to the side for use during the installation of your new exhaust system.
4. Lubricate all hangers and rubber isolators.
5. Using a muffler stand or an additional person to hold the original exhaust up into position, remove all the hangers from the rubber isolators and then remove the entire exhaust system.
source
Tuesday, May 11, 2010
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment