At the Conner Avenue Assembly Plant, workers called “Craftspersons” hand-build the new Dodge Viper SRT10 and all-new 600-horsepower 8.4-liter SRT V-10 engine. Utilizing 26 work stations on a 705-foot-long assembly line, 48 hand-picked UAW workers assemble each vehicle. Each vehicle remains stationary for up to 49 minutes per work area as the Craftspersons make any necessary adjustments. This process eliminates traditional repair stations with all procedures verified by Craftsperson team members.
Each Dodge Viper is primarily made of seven component modules (instrument panel, fuel tank, suspension corner modules, wheels and tires, cooling module, lift gate assembly and full dressed engine). With the exception of the engine, all modules are shipped to the Conner facility from other locations. Stamping, casting and welding all take place off-site with body panels arriving already painted.
Normally performed only on race cars, an alignment machine sets caster and camber at normal ride height, at jounce and at rebound (upward and downward travel of suspension). Typical factory alignments set caster and camber in the normal ride height position only. The 2008 Dodge Viper SRT10 is the only U.S. production vehicle set up for such alignment at the factory.
“Our assembly process is just as exceptional as the car,” said Melissa Holobach, Plant Manager – Conner Avenue Assembly Plant, Sterling Heights Vehicle Test Center (SHVTC) and Pilot Operations. “The process of building these vehicles by hand has allowed us the freedom to produce race-inspired performance without the constraints of mass production,” Holobach said. “Our workforce is committed to producing the best vehicles possible and it shows in their commitment to detail.”
0 comments:
Post a Comment