Bumpers Refer to the following illustrations when performing Removal and Installation procedures on the front and rear bumper assemblies. CAUTION: Never apply excessive heat to bumper surface. Heat could cause distortion of the bumper. CAUTION: When collecting exhaust fumes in service area, never attach a metal collector to the exhaust tail pipe because the heat could damage the bumper.
Bumper, Front, Taurus/Sable Except SHO 1 17750 Front Bumper Assy 2A N804984-S100 Screw and Washer (1 Req'd Each Side) 3 17D809 Isolator and Bracket Assy 4C N606689-S2 Screw and Washer Assy (3 Req'd Each Isolator) 5B N805433-S54 Screw and Washer (3 Req'd Each Side) 6 N800538-S101 U-Nut (1 Req'd Each Side) 7 N805150-S Rivet (3 Req'd) (Sable) 8 17N397 Bracket Assy (Sable) A Tighten to 9-21 Nm (7-15 Lb-Ft) B Tighten to 22-34 Nm (17-25 Lb-Ft) C Tighten to 17-27 Nm (13-19 Lb-Ft)
Source
Saturday, May 29, 2010
1993 Taurus/Sable Bumpers Removal and Installation
11:04 PM by onesecond
·
Labels: 5b, bumpers, excessive heat, exhaust fumes, Ford, front bumper, illustrations, installation procedures, isolator, lb ft, rear bumper, req, rivet, sable, screw, surface heat, tail pipe, taurus
Labels: 5b, bumpers, excessive heat, exhaust fumes, Ford, front bumper, illustrations, installation procedures, isolator, lb ft, rear bumper, req, rivet, sable, screw, surface heat, tail pipe, taurus
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment