The B&M QuickSilver Shifter can be used in most vehicles equipped with three speed or four speed automatic transmissions. Your B&M QuickSilver Shifter comes equipped with a neutral safety switch and a backup light switch, trans- mission brackets, levers and a five foot shift cable. Optional shifter cables in 2 ft. (#80830), 3 ft. (#80831), 4 ft. (#80831), 8 ft. (#80831), 10 ft. (#80835) and 12 ft. (#80836) are also available. To use the B&M QuickSilver Shifter with the Ford AOD transmissions you will need the optional accessory kit #40496.
To use this shifter with a GM four speed automatic transmission, you will need to remove the three speed limiter blocker pin and the two e-clips (See Figure 1). For the Ford AOD four speed transmissions do not remove this blocker pin.
To use this shifter with a Ford or Chrysler automatic transmission, install the blocker pin and the two e-clips (See Figure 1). This limiter limits the travel of the shifter when it is shifted into Park, so that it does not stretch the cable. Please read the instructions and review the illustrations thoroughly before beginning the installation.
The mechanical components of this shifter are precision made and assembled at our factory. Any modification or disassembly of these parts can cause the shifter to malfunction and will void the warranty. You should disassemble only those items outlined in the instructions.
The vehicle should be about 2 feet off the ground for ease of installation. Use jack stands, wheel ramps or a vehicle lift. Make sure the vehicle is firmly supported before attempting to work on it.
source
Thursday, May 27, 2010
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment