NV_RGB_X OEM Navigation Dual Video Input Interface Module With Wiring Harness

Pre-Installation Disclaimer:
By purchasing and installing our products, you agree that NAV VIDEO Inc., its employees and affiliates cannot be held responsible for any accidents, tickets, misuse of products or damage caused to your vehicle. The driver must always keep their eyes and attention on the road at all times. Our products are intended for passenger entertainment and off-road use. In some states it is illegal to have a TV viewable by the driver while the vehicle is in motion, please obey your state laws. In addition it is your responsibility to provide this disclaimer to any party that may purchase your NAV VIDEO navigation interface from you, in or out of your vehicle. NAV VIDEO cannot be held responsible for discrepancies, or inconsistencies that may occur due to vehicle manufacturing changes. Please adhere to all state and federal laws when operating your video interface.

RGB Module Connections & Controls
The NV_RGB_X Video Interface is capable of both single video and dual video modes of operation. For dual video mode, the optional remote control pad is recommended for switching between the video inputs on the module.

Installation With Plug And Play Factory Harness
If your RGB unit came with an OEM fit factory harness, simply find the GPS navigation computer (either in the trunk, under a seat, or behind the LCD head unit) and remove the existing factory connector attached to it. Plug the new RGB wiring harness in, then connect the vehicle connector to the other end of the new RGB wiring harness. Each vehicle manufacturer varies, but in general here are the locations we recommend for each respective manufacturer.

source