Audi RVC Interface Installation Instructions

Installation requires special knowledge.
Do not install the unit yourself. For safe and reliable installation, consult a dealer having special knowledge.
• Never use bolts or nuts from the car’s safety devices for installation. If bolts or nuts from the steering wheel, brakes or other safety devices are used for installation of the unit, it may cause an accident.
• Use the unit with a DC 12V negative ground car. This unit cannot be used in large trucks which use a DC 24V battery. If it is used with a DC 24V battery, it may cause a fire or accident.
• Avoid installing the unit in following places:
- Where it would hinder your safe driving.
- Where it could damage the car’s fittings.
• This unit is only for use in the following vehicles. Only connections described within this instruction guide are allowed or required to use for installation.
• For damage impact caused by faulty installation, unsuitable connections inappropriate vehicles Kufatec GmbH assumes no liability.
• We advise you that these units process datas out of the CAN - protocol from the vehicle. As the supplier of this device we don‘t know the overall system you are working with. If our device causes damage due to other changes made by to the vehicle Kufatec GmbH assumes no liability.
• Kufatec GmbH supplier do not guarranty the use of the product for changings within a new vehicle series.
• If the car manufaturer‘s don‘t agree with the installation of our device by reason of warranty the Kufatec GmbH assumes no liability. Please check conditions and warranty before you begin the installation.
• Kufatec GmbH supplier reserves the right to change the device specifications without notice

Installation Instructions
Please remove the head unit using suitable tools,
With the connection of 4 new wires you will complete the fitting of the interface. Please see scheme below
(blue marked figures). In order to achieve a proper connection we recommend both crimping and solding
the new wires.

NOTE: The rear view camera must not be connected to the cinch input of the Interface. Please see page 5, 6 for PIN configuration

source