VW IHF1000 Bluetooth Handsfree System Installation Instructions

Preparations
• Slide back the front seats to the rear-most and lower-most positions.
• Turn the ignition key to the Off position.
• Disconnect the battery negative lead.
CAUTION!
Failure to disconnect the battery negative lead could result in failure codes being registered by Electronic Modules in the vehicle. Once set, these fault codes may only be cleared by manufacturer-specific diagnostic tools.

Harness Installations
• Remove the radio and install the VW/Audi radio-specific handsfree adapter harness. Refer to the VW/Audi dealer instructions for adapter harness installation.
• Connect the IHF1000 interface harness’s 8-pin White connector to its mate on the VW/Audi handsfree adapter harness.
• Route the IHF1000 Handsfree Module connector to the desired Handsfree Module mounting location. See the Handsfree Module Installation section of these instructions for more detail.

Microphone Installation
Note! Please review the Microphone Installation Warning Sheet included in the IHF1000 kit before installing the microphone. Proper placement of the microphone is essential for optimal Handsfree and Speech Recognition performance.
• Identify a location on the overhead dome light/console assembly to mount the IHF1000 microphone.

User Interface Module (UIM) installation
Determine a suitable mounting location for the UIM. The UIM should be within a comfortable reach of the driver for ease of use.
• Remove the backing of the tape on the bottom of the User Interface Module (UIM).
• Place the UIM in the desired location and mount the UIM with a firm press.
• Route the UIM cable behind the dashboard and trim, across to the desired Handsfree Module mounting position.

source