U-Cut-To-Fit GM & Chrysler Speedometer Cable Kit Installation Instructions

U-Cut-To-Fit Speedometer Cable Kit Installation
Step 1: Install outer housing to speedometer and route housing to transmission, making sure to keep away from exhaust pipes.
Step 2: Hold housing up to transmission to determine length and mark a cut line. Remove housing from vehicle and cut housing at the cut line.
Step 3: After cutting housing, install end of housing into GM or Chrysler trans end fitting. Figure 1 Slide housing nut up and tighten until housing is locked into fitting.
Note: Do Not over tighten nut as it will result in fitting failure.
Step 4: Install inner cable into the housing with the square end towards the transmission gear. Install inner cable into gear, making sure it bottoms out in this gear. Screw trans end fitting on trans and route housing to speedo with the inner cable installed. At the speedo head, mark inner cable flush with the end of the speedo end fitting. Figure 3
Step 5: Remove inner cable. Cut at mark, debur inner cable and install tip.
Step 6: Place inner cable and tip (A) into crimping die (B). Figure 4
Step 7: Make sure tip is pushed onto inner cable completely. Using pliers, hold crimping die onto a solid surface and strike squarely with a hammer.
Step 8: Remove crimping die by prying apart with a screwdriver.
Step 9: Before final installation of inner cable into outer housing, LUBRICATE with light grease. Install in car.

source