Mopar Remanufactured Single Board Engine Controller (SBEC) Removal & Installation

This MOPAR Single Board Engine Controller is warranted by Chrysler Corporation against defects in workmanship or materials for 12 months or 12,000 miles, whichever comes first, from the date of its installation into a Chrysler, Plymouth, Dodge, Jeep or Eagle vehicle. If it fails, it will be repaired or replaced, at the option of Chrysler Corporation. To obtain service under this Limited Warranty, return the module to an authorized Chrysler Corporation Dealer.

This is the only warranty to this computer. If this computer is not sold for installation into a vehicle which is operated for personal, family or household purposes, Chrysler disclaims any implied warranties which may pass with the sale of this computer, to the extent allowed by law. If this computer is sold for installation into a vehicle which is operated for personal, family or household purposes, Chrysler limits the duration of any implied warranties to the duration of the express warranty made above. Under no circumstances will Chrysler be liable for any incidental or consequential damages which may result from the breach of any expressed or implied warranty, including any liability for loss of use or diminished value.

Removal Procedure
Passenger Cars, Minivans & Full Size Pickups (Mounted to left front fender wall) When replacement of Single Board Engine Controller (SBEC) is necessary proceed as follows:
1. Remove air cleaner duct from SBEC.
2. Remove battery (if needed).
3. Remove the 60 way connector for the wiring harness using an 8mm socket (Fig. 1a, b c)
4. Using the same socket, remove the (2) module mounting screws {(3) screws on full size pickup} (Fig. 1a, b, c)
5. REVERSE the above procedure for INSTALLATION.

source