Chrysler Pasifica DVD Rear Seat Video System Installation

A – Interior Trim Panel and Component Removal:
1) Disconnect and isolate negative battery cable.
2) Detach the center console shift bezel.
3) Remove ignition key bezel.
4) Remove left and right I/P center bezels using a non-metal trim stick.
5) Disconnect and remove the CD/DVD player or cubby bin (four phillips screws).
6) Disconnect and remove the radio (four phillips screws).
7) Remove right (passenger’s side) A-pillar trim panel (one phillips screw).
8) Remove right side I/P access panel.
9) Disconnect and remove right sunvisor (two T20 screws).
10) Remove right sunvisor clip (one T20 screw).
11) Remove right front headliner grab handle (two phillips screws).
B – Trim Out the Headliner:
1) Trim out supplied template (Item 1) along the dotted lines.
2) Position template to the headliner, making sure that it aligns to the left and right grab handle assemblies.
3) Secure template to headliner where indicated using new masking tape.
4) Trim out the headliner per template instructions using a sharp utility knife.
C – Install Overhead Harness:
1) Position overhead harness (Item 2) to the right A-pillar as shown. Secure it to the existing harness using two tie straps (Item 3).
2) Carefully pull headliner down just enough to allow the overhead harness to route rearward.

source