Cadillac CTS 2008-2011 In-Car Router Installation

1. On left wall of trunk, remove the three fasteners that secure the trunk liner.
2. Remove Velcro attached net storage if equipped.
3. Open left rear passenger door fold down seat and remove two remaining fasteners that secure trunk liner.
4. Remove trunk liner.
5. Using Router Docking Station as a template, drill or punch four 1/8” diameter holes in level area near rear of trunk liner. Use caution-insulation located behind this area can bind in drill bit.
6. Attach docking station using four supplied nylon Key Hole clips.
7. Drill a 3/8” hole directly below docking station for power wire.
8. Run power wire through hole in trunk liner. Secure in place with grommet.
9. Attach black lead of supplied power cable to ground stub on rear wheel well of trunk using supplied nut.
10. Feed cable through seat frame into passenger cabin.
11. Run power cable under trim to left instrument panel access area on the driver’s side of dash.

source