2007-2009 Jeep Wrangler 4-Door and 2-Door Audio System Upgrade Package

Radio Removal
1. Using a panel removal tool pry up on the plastic trim panel located above the radio. Make sure to pry on the side of the panel closest to the window.
2. Using a panel removal tool pry loose the top edge of the panel below the HVAC controls.
3. Using a 7mm nut driver remove the four screws securing the radio trim bezel. There are two at the top and two at the bottom.
4. Starting at the top and working your way down pull out on the trim bezel to release the fasteners securing it. Once the bezel is completely detached from the dash it is not necessary to disconnect any of the wiring or the HVAC linkage. Simply allow the bezel to rest on the console to allow access to the screws securing the radio.
5. Remove the screws securing the radio and pull the radio from the dash and disconnect the wiring. Disconnect the antenna cable by pulling the locking antenna connector away from the radio.
Caution: Pulling the antenna cable straight out of the radio without pulling on the locking antenna connector could damage the cable or radio.
6. Gently pull out on the panel just below the steering column, rotate down and remove.
7. Find the small panel just below the one you just removed and pull to remove it as well.
8. Using a 10mm socket and ratchet remove the two 10mm bolts securing the metal plate below the steering column.
9. Install the amp bracket in between the dash frame rails and line up the holes in the bracket with the holes. Install the supplied 10mm bolt in the lower middle hole but do not tighten.
10. Temporarily install the two bolts that retain the metal plate in order to stabilize the amp bracket while the amp is mounted.

source