2005+ Chrysler Vehicles Auxiliary Audio Input Installation

Installation:
The CHYX plugs into the back of the factory radio.
1. Remove factory radio. Remove factory female 10 pin Satellite cable, if available. Plug the CHYX’s 10 pin SAT plug into the radio. Plug the factory Satellite cable that was just removed into into the CHYX’s 10 pin connector.
2. Insert the CHYX’s 22 pin main power Plug (T-Harness) in between the factory radio and factory harness.
3. Connect external audio devices(s) into Aux 1 and/or Aux 2 inputs using the RCA jacks on the CHYX.
4. If the vehicle has both factory Satellite and VES, you must disconnect either one directly at the device. If the vehicle has factory single disc radio, the Satellite receiver must be disconnected directly at the device . Refer to vehicle’s repair manual for location and removal of the Satellite receiver or VES plug.
5. By default the CHYX output plug (3 pin connector) should be connected to the the VES input harness of the 10 pin t-harness. If the vehicle has factory VES or the factory radio is a single disc (REF), use the Satellite input of the 10 pin t-harness.
Note: The CHYX will emulate the VES by default. If the vehicle has factory VES or the radio is a single disc, the CHYX will emulate the Satellite receiver automatically.
RED wire with fuse holder: Accessory Output. You can use this wire to turn on DVD/VCP players. This wire provides a +12 volt output when key is in accessory or ignition position. The output is 1 amp max, use relay when neccessary. Insulate end if not used. Warning! Do Not connect this wire to the vehicle’s accessory/ ignition wiring.

source