2002 Jaguar X-Type V6-2.5L Transmission Fluid Level Check Inspection

1. Raise and support the vehicle.
2. Connect the approved Jaguar diagnostic system.
3. Make sure J-Gate shift selector is in the Park position (P).
4. With the engine running and the foot brake applied, move the J-Gate shift selector
through "P-R-N-D-4-3-2" and back to the "P" position to circulate the automatic
transmission fluid until the temperature reaches 30 to 40°C (86 to 104°F) on the
approved Jaguar diagnostic system.
5. When the automatic transmission fluid temperature reaches 35°C (95°F) check
that the selector lever is in the "P. position raise the vehicle.
6. With the engine running, remove the automatic transmission fluid level tube plug.
Remove and discard the sealing washer.
7. If the automatic transmission fluid does not come out of the transmission fluid level
tube the automatic transmission fluid level is insufficient. If this is the case add the
automatic transmission fluid in 0.5 litre units into the automatic transmission fluid
charging pipe until the automatic transmission fluid comes out of the automatic
transmission fluid level tube.
Remove the automatic transmission fluid charging pipe cap.
NOTE: Use automatic transmission fluid WSS-M2C922-A1 or equivalent meeting Jaguar
specification.
8. Allow the automatic transmission fluid to come out of the automatic transmission
fluid level tube until the overflow stops at a temperature of no more than 40°C
(104°F). NOTE: Make sure the automatic transmission fluid temperature does not
exceed 40°C (104°F) . If the automatic transmission fluid temperature does
exceed 40°C (104°F) stop the automatic transmission fluid level check and allow
the automatic transmission fluid to cool until the temperature reaches 30 to 40°C
(86 to 104°F).

Source