2001-2003 Chrysler Sebring Coupe Lxi Cold Air System Installation

Removing the stock air inlet system
a) Disconnect the breather hose from the stock inlet piping and set aside as it will be used in the installation of the AEM intake.
b) Remove the two hose clamps securing the stock inlet piping.
c) Disconnect the air flow sensor wire harness.
d) Disconnect and remove the stock inlet piping.
e) Remove the two plastic hold downs on the air inlet funnel.
f) Disconnect and remove the air inlet funnel from the stock air box.
g) Remove bolt holding the stock air box to the mounting bracket.
h) Disconnect and remove the stock air box.
i) Remove the two bolts securing the mounting bracket to the body.
j) Remove the mounting bracket.
k) Remove the 4 nuts holding the air flow sensor to the stock air box.
l) Remove the air flow sensor and set aside as it will be used in the installation of the AEM Intake.
i) Note: Be careful with the air flow sensor as it can be damaged easily. Set the air flow meter aside in a safe place.

Installing AEM’s Cold Air System
a) On the last page of these instructions are photos to help you with the installation of your AEM Intake
b) When installing the AEM intake, DO NOT completely tighten the hose clamps, air flow sensor assembly or the mounting tab hardware until instructed to do so later in these instructions.
c) Install the black rubber elbow on the throttle body. The short side of the rubber elbow towards the throttle body and the long side towards the front of the vehicle. Install a 2.75” hose clamp on the throttle body end of the rubber elbow and snug it down. (Fig. 1)
d) There are two inlet pipes supplied with this kit the primary and the secondary. The primary inlet pipe will be the pipe with the breather hose nipple. The secondary inlet pipe will be the pipe with the mounting bracket.
e) Install the end of the primary pipe closest to the breather nipple into the exposed end of the rubber elbow. Install a 2.75” hose clamp onto the inlet pipe end of the rubber elbow and snug it down.

source