1999–01 Honda Odyssey EX Power Sliding Door(s) Do Not Work

One or both power sliding doors do not work, the power sliding door indicator light is on, and DTC 25 is set.
PROBABLE CAUSES
• Loose or poor connections at ground G551, G552, G581, and G582.
• Misalignment or poor contact of the door or body junction switch pins. CORRECTIVE ACTION
• For all 1999 vehicles and 2000 vehicles thru VIN 2HKRL....YH603416, do REPAIR PROCEDURE A and REPAIR PROCEDURE B.
• For 2000 vehicles above VIN 2HKRL....YH603416 and all 2001 vehicles, do REPAIR PROCEDURE B.
REPAIR PROCEDURE A: Clean the affected grounding points, and install star washers. If this repair was done earlier, do only REPAIR PROCEDURE B.
REPAIR PROCEDURE B: Replace the door and body junction switches. Adjust both sliding doors, then align the junction switches.

REPAIR PROCEDURE
1. Make sure you have the anti-theft code for the radio and for the navigation system (if equipped), then write down your customer’s radio station presets. 2. Open the power sliding doors. 3. Disconnect the negative cable from the battery. Failure to disconnect the negative cable may damage the power sliding door control units. 4. Remove the left and right center pillar trim pieces (see page 20-57 of the 1999–02 Odyssey Service Manual).

Source