Chevrolet Silverado Rear Vision System Nav Display Installation Instructions

Preparation
1. Ensure all lamps and accessories are OFF.
2. Ensure the ignition switch is in the OFF position.
3. Loosen the negative battery cable bolt. Remove negative battery cable from terminal and position away from battery.
4. Wait one (1) minute prior to working on the vehicle to assure SIR roof rail airbag system has been disabled for your safety.
Install Camera into Endgate
5. Lower Endgate and remove center bezel mounting bolt (1), using 13mm socket.
6. Release, by hand, the three retainer clips securing the bezel (2) to the Endgate outer panel. Lift the Endgate latch handle in order to aid in the removal of the latch handle bezel. Figure 1.
7. If the Truck is not equipped with Endgate Lock (&A60), remove the two upper Endgate Latch Handle Bolts (1) from the Endgate Latch Handle (2), using 13mm socket. Figure 2. Release Rods before removing (inset). If equipped, skip this step.
8. Prepare a work surface for the Endgate, as it will be removed.
9. Disconnect the two Endgate support cables.
10. With the aid of an assistant, remove the Endgate and locate to clean work surface.
11. Locate the supplied Template Sheet for the Endgate and Pickup Box Sill.
12. Cut out Endgate Template and attach to Endgate using tape. Using the Center Punch, mark the center of hole.
13. Cut out Sill Plate Template and attach to Pickup Box Sill using tape. Using the Center Punch, mark the center of hole.
14. Using a drill motor and a 29mm (1-1/8”) Hole Saw, cut out the harness pass-through in the Endgate.

Source