1993-2001 Nissan Altima TWM Performance Short Shift Kit Installation Manual

It is preferable to park on a flat surface, as you may have to engage and disengage the hand brake and shift from gears to neutral. If you cannot do so and are obliged to install the short shifter on a slightly inclined surface, place wooden blocks in front or behind the wheels to prevent the car from moving while you’re working.
Estimated Installation Time: 120 minutes
Tools required: - Flat head screw driver (large and small) - Philips head screw driver - Needle nose pliers - Ratchet - 8 mm socket - 10 mm socket - 12 mm socket - 7/16” socket - All purpose grease - WD-40 or any rust-remover product
1. Remove shift knob by rotating it counter-clockwise. Some Nissan shift knobs are glued and may be difficult to unscrew. In this case, use a leather piece of fabric and wrap it around the knob. Use a Cobra-style wrench to unscrew it from the shaft. When this is done, shift into 5th gear.
2. In most models, the plastic console surrounding the shifter can be unclipped. Hold the rear part of the console by the opening of the shift boot and pull up on it.
4. In most models, there should be 2 other screws at the rear of the console. For this step, it is easier to push the front seats forward to access and remove these screws.
5. The console is now ready to be removed. Lift the front of the console to be able to disconnect plugs (if you have heated seats). If you have leather boot partially covering your handbrake lever, it may be necessary to unsnap it (from below).
3. Steps 3, 4 and 5 are not necessary for the shifter installation, but can make the process easier, by having more space to work. First, remove the 2 screws at the front of the console.

Source