Borla Performance Cat-Back™ Exhaust System (Part number 140188) has been designed for the 2006 Dodge Ram SRT-10 Crew Cab and Regular Cab, Short Bed, equipped with a 8.3L V-10 engine and automatic or manual transmissions.
Caution!!! Never work on a hot exhaust system. Serious injury in the form of burns can result If the vehicle has been in use and the exhaust system is hot, allow vehicle to cool for at least 1 hour. Always wear eye protection when working under any vehicle.
Note: It is our recommendation that you use a hoist or hydraulic lift to facilitate the installation of your new Borla Performance Cat-Back ™ Exhaust System.
Taking all under car safety precautions, lift the vehicle using a hoist or hydraulic lift. Once this has been done, you may begin the removal of your old exhaust system from your vehicle.
Note: Before removing the original exhaust system from your vehicle, please compare the parts you have received with the bill of materials provided on the previous page to assure that you have all the parts necessary for the installation of your new Borla Performance Cat-Back ™ Exhaust System.
Borla Performance Cat-Back ™ Exhaust System Installation
1. Place a clamp over the expanded ends of the muffler assembly and set it into position as shown in figure 4 making sure to install the hangers into the rubber isolators. Do Not tighten the clamps.
2. Place a clamp over the expanded outlets of the muffler assembly and set the muffler outlet pipes into position as shown in figure 5. Do Not tighten the clamps.
3. Place a clamp over the expanded ends of the tail pipe assembly and set it into position as shown in figure 6 making sure to install the hangers into the rubber isolators. Do Not tighten the clamps.
4. Check your exhaust system for proper clearance under the vehicle and also for tip alignment.
5. Once position has been determined to be correct, tighten the Accuseal™ clamps to 32-35 ft. lbs.
Source
Monday, December 13, 2010
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment