94-01 Dodge 1500 Lift Kit

This kit is packaged as a leveling kit—raising the front 5” and the back 4”. If you desire a different look or if your truck has a tool box or added weight in the rear please consult with your sales representative about other block and u-bolt options or the use of an add-a-leaf. The 5” suspension system was developed for a 35x12.50x15 tire on an after market wheel with 5” of back spacing.
NOTICE TO DEALER AND VECHICLE OWNER
Any vehicle equipped with any Rough country product must have the “Warning to Driver” decal installed on the sun visor or dash. The decal is to act as a constant reminder for whoever is operating the vehicle of its unique handling characteristics. INSTALLING DEALER—It is your responsibility to install the warning decal and to forward these installation instructions on too the vehicle owner for review and to be kept in the vehicle for its service life.
FRONT INSTALLTION INSTRUCTIONS
1. Block the rear wheels of the vehicle. Raise the front of the vehicle and support the vehicle with jack stands under the frame rails. Remove the front wheels and tires and set aside. Position a hydraulic jack under the front axle and raise the jack until the front suspension begins to compress.
2. On both sides of the vehicle, scribe alignment marks on the adjustment cam and axle bracket at the lower link to axle attachment point for later reference.
3. Unbolt the brake line brackets from the axle to ensure brake line free play during the suspension system installation. Remove the center disconnect vacuum lines from the clamp on the axle.
4. Remove the nut, retaining washer and rubber bushing from the both upper shock mounts located inside the engine compartment.
5. Remove the lower shock bolts on the axle and save for later installation. The shock absorbers will be removed from the vehicle at the same time the coils are removed from the vehicle.

Download