3300 SuperGlide Installation Instructions

This guide provides several pages of instructions for the installation of the SuperGlide towing system (part number 3300).
Truck Preparation
1. Check part quantities using the Parts List for the specific vehicle type.
2. Block vehicle wheels. Some vehicles may require you to raise the rear of the truck in order to make it easier to drill for installing the Mounting Brackets on the truck frame.
3. You may wish to remove the wheels, to give yourself greater working room.
4. At this point, the bed should be laid out and marked for drilling using either the LAYOUT METHOD or the TEMPLATE METHOD.
1. For layout using the Template method, see Layout (Template Method) on next page.
2. See Truck Bed Layout Dimensions table pg. 5 for the dimension values for items A-D located in the ‘LAYOUT METHOD’ illustration. Measure and mark from the back of the bed forward the values for A and B. Do this at any point on both sides of the bed.
3. Draw a line across the bed from mark to mark.
4. Find the centerline of the bed. Draw a line down the middle of the bed from front to rear. See Figure 3 on pg. 5. Center the measurement of C across the centerline at the front most line you made in step 2, and mark the measurement on each side (parallel to the centerline). Center the measurement of D for the rear most line made in step 2, and again mark the measurement on each side (parallel to the centerline). This will locate the 4 drill holes.
5. Go to the Index and look for your truck SPECIFIC LISTING and do the steps listed in PART I. The truck Specific Listings begin after page 5 of these instructions. (See the Table of Content for your specific application).

Download