While developing this product, your personal safety combined with the best operating service, modern design and an up-to-date production technique was especially taken into account. Unfortunately, despite the utmost care injuries and/or damages might occur due to improper installation and/or use. Please read the attached instruction manual completely with great care and keep it! All articles of our production line pass through a 100 % check - for your safety and security. We reserve the right to carry out technical changes which serve the improvement at any time. According to each article and purpose, it is sometimes necessary to check each country’s legal regulations before installing and starting the unit.
Installation instruction
1 – CD device Audi A4 8K, A5 8T, Q7 4L
2 – CD device Audi A6 4F /
2 - AMI Audi A6 4F, A4 8K, A5 8T
3 – Telephone interface (behind the glove box)
4 – Microphone (Interior light)
Audi A4 8K, A5 8T
Loosen the necessary screws of the glove box (Fig. 9 - 11). Disconnect the original wiring of the CD/AMI device (if available).
Remove the cover shown on figure 12. Mount the interface to the back of the glove box by using suitable fastener
Remove the airbag sign by using suitable tools (in order to avoid damages) and loose the screw located behind.
NOTE: Does the vehicle have airbags fitted along the A-column it is essential to wire the loom for the microphone BEHIND the airbag. Wire the loom without putting tension on it. Mount the loom without affecting the airbag in it’s functionality.
Open the storage of the interior light and loose the screw (Fig. 19). Mount the microphone on the original location within the interior light – driver’s side
Audi A6 4F
Loosen the necessary screws of the glove box (Fig. 22, 23). Disconnect the original wiring of the CD/AMI device (if available). Mount the interface to the back of the glove box by using suitable fastener.
Source
Sunday, October 31, 2010
Subscribe to:
Post Comments (Atom)
0 comments:
Post a Comment