00-05 Mitsubishi Eclipse Front Kit Part No. 75504

Always keep safety in mind when working on your vehicle. Completely read these instructions before installing the kit.
Preparing the Vehicle
1. Elevate the vehicle and secure the frame with jack stands.
2. Remove the front wheels.
Strut Removal
1. Remove the three nuts securing the upper strut mounting bracket and discard.
NOTE: These are located inside the engine compartment above the strut pocket.

1993-96 Chevrolet Camaro Shaft and DIN Unit Provisions

Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (2) Phillips screws from the top of the driver's side knee bolster. Remove (2) 7mm screws from the bottom of the knee bolster. Open the glove box, remove (3) 7mm screws exposed on the right edge of the radio trim bezel and remove the bezel. Remove (2) 7mm screws securing the left side of the factory head unit and (1) 10mm nut securing the right. Slide the unit from the dash and disconnect the wiring. Cut and remove all mounting tabs on the Radio Housing EXCEPT tabs "A". The mounting tabs can be identified by the stamped letter on the back of each tab. Skip to the Installation Instructions for ALL VEHICLES on Page #5.

2006 Acura TL Power Steering Removal

This manual contains STEERING WHEEL REMOVAL for Acura TL.
SRS components are located in this area. Review the SRS component locations (see COMPONENT
LOCATION INDEX ) and the precautions and procedures (see PRECAUTIONS AND PROCEDURES )
before performing repairs or service.
1. Make sure you have the anti-theft codes for the radio and the navigation system, then write down the
customer's audio presets.
2. Align the front wheels straight ahead, then remove the driver's airbag from the steering wheel (see
DRIVER'S AIRBAG REPLACEMENT ).

GM / Chevy / Cadillac (GMT800) Telescopic Trailer Tow Mirror Fitting Instructions

Made by the world’s largest manufacturer of exterior mirrors, the Telescopic Trailer Tow Mirror combines great looking aerodynamic styling with the toughness only a company like Schefenacker can produce. You’ve chosen one of the hottest new products in the past few years! Its interchangeable covers mean you can personalize the looks that suit you and your pick up, and a wide range of options mean you can have the right equipment for the right job.

6-Speed Short Shift Install

1. Open the package and make sure you received all the appropriate parts.
There should be:
• Cast Shifter Arm
• Five (5) small weights
• Two (2) large weights
• One (1) shifter arm pin c/w lock washer
• Six (6) bolts: (2) short, (2) medium and (2) long, lock washers(2)
2. Start by getting all the appropriate tools that you will need:
• Flat-blade screwdriver
• Phillips screwdriver
• 10mm wrench and socket
• 13mm socket
• 14mm wrench/socket