C3100 Speaker Universal Mounting Bracket Kit

Selecting a Mounting Location: The mounting location should not only be as flat as possible but also, allow the siren to project its tone parallel to the road.
For detailed information on mounting locations for certain specific vehicles, see the following pages.
Installation: Position the bracket onto the desired mounting area and mark the centers of the 4 mounting holes using the bracket as a template.

1996-1998 ACURA 3.5 RL w/o GPS Part Number AC-55-96 Instructions

STEP 1. Begin by inserting the hook tool underneath the right rear corner of the black trim bezel that surrounds the shifter lever. Pull upward to release one (1) plastic clip. Perform this same action in the remaining three (3) corners on the bezel, releasing three (3) more plastic clips. Slide the bezel over the shifter knob and disconnect all wiring. Set the bezel aside. Remove the wood grain trim bezel that surrounds the shifter. This bezel also has the ashtray integrated into it. Insert your hook tool underneath the right rear corner of this bezel and pull upward to release right rear clip. Insert the hook tool underneath the left rear cor- ner of the bezel and pull upward to release left rear clip. There are two more clips holding the bezel in place located in front of the shifter just behind the ashtray. Insert your hook tool between the center console padding and the trim bezel on the right side of bezel. Pull upward to release clip. Perform this same action on the left side. Grasp the

1993-96 Chevrolet Camaro Shaft and DIN Unit Provisions

Disconnect the negative battery terminal to prevent an accidental short circuit. Remove (2) Phillips screws from the top of the driver's side knee bolster. Remove (2) 7mm screws from the bottom of the knee bolster. Open the glove box, remove (3) 7mm screws exposed on the right edge of the radio trim bezel and remove the bezel. Remove (2) 7mm screws securing the left side of the factory head unit and (1) 10mm nut securing the right. Slide the unit from the dash and disconnect the wiring. Cut and remove all mounting tabs on the Radio Housing EXCEPT tabs "A". The mounting tabs can be identified by the stamped letter on the back of each tab. Skip to the Installation Instructions for ALL VEHICLES on Page #5.

2004-2006 Ford F-150 Liquid Solid Billet Door Handle Instruction

The installation of the replacement door handles are for persons with advanced auto-body skills and is recommended to have them professionally installed.
A. Pre-installation Preparation
Step 1: Verify kit contents.
Step 2: Remove the door handles from the box.
Step 3: Make sure the window is up and the door is unlocked.