Installation procedure the grille guard on Honda CR-V
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY.
2. Using a flat screwdriver carefully remove all fasteners from factory plastic shroud on top and underneath the vehicle. On the bottom there are (4) on the front and (3) on each side by the fender. On the top there are (7) fasteners.
3. Remove bottom plastic shroud and place it on a working area. Using a hack saw carefully cut the marked area shown in Figure 1.
Showing posts with label flat washers. Show all posts
Showing posts with label flat washers. Show all posts
Tuesday, November 9, 2010
07 Honda CR-V Grille Guard Installation Instructions
3:32 AM by onesecond
·
0
comments
Labels: factory bumper, fasteners, fender, flat screwdriver, flat washer, flat washers, grille guard, hack, head bolt, hex head, holes, Honda, honda cr v, mounting bracket, mounting brackets, radiator, radiator support, rear hole, shell, shroud
Labels: factory bumper, fasteners, fender, flat screwdriver, flat washer, flat washers, grille guard, hack, head bolt, hex head, holes, Honda, honda cr v, mounting bracket, mounting brackets, radiator, radiator support, rear hole, shell, shroud
Sunday, September 19, 2010
00-05 Mitsubishi Eclipse Front Kit Part No. 75504
9:51 PM by onesecond
·
0
comments
Labels: 7a, bearing, bolts, engine compartment, flat washers, holes, loctite, Mitsubishi, mitsubishi eclipse, mounting bracket, nuts, rubber bushing, rubber side, shaft, strut assembly, sway bar link, thread sealant, wheels
Labels: 7a, bearing, bolts, engine compartment, flat washers, holes, loctite, Mitsubishi, mitsubishi eclipse, mounting bracket, nuts, rubber bushing, rubber side, shaft, strut assembly, sway bar link, thread sealant, wheels
Always keep safety in mind when working on your vehicle. Completely read these instructions before installing the kit.
Preparing the Vehicle
1. Elevate the vehicle and secure the frame with jack stands.
2. Remove the front wheels.
Strut Removal
1. Remove the three nuts securing the upper strut mounting bracket and discard.
NOTE: These are located inside the engine compartment above the strut pocket.
Preparing the Vehicle
1. Elevate the vehicle and secure the frame with jack stands.
2. Remove the front wheels.
Strut Removal
1. Remove the three nuts securing the upper strut mounting bracket and discard.
NOTE: These are located inside the engine compartment above the strut pocket.
Subscribe to:
Posts (Atom)
