07 Honda CR-V Grille Guard Installation Instructions

Installation procedure the grille guard on Honda CR-V
1. REMOVE CONTENTS FROM BOX. VERIFY ALL PARTS ARE PRESENT. READ INSTRUCTIONS CAREFULLY.
2. Using a flat screwdriver carefully remove all fasteners from factory plastic shroud on top and underneath the vehicle. On the bottom there are (4) on the front and (3) on each side by the fender. On the top there are (7) fasteners.
3. Remove bottom plastic shroud and place it on a working area. Using a hack saw carefully cut the marked area shown in Figure 1.

1940-1946 Chevy Pick-up Truck Crossmember Kit Installation Instructions

Truck Crossmember Kit installation for Chevrolet Pick-up
1. Start by supporting the truck on 4 jack stands. The truck should be sitting at approximately the same angle as it does on the ground or slightly lower in front.
2. Remove all the old suspension components from the frame. The front spring shackle mounts riveted in the frame are used for a measuring point. The top of the frame rail should also be flattened in the area where it is turned up for the old steering box mount.
3. The radiator support crossmember will need to be modified next. Figure 1 shows the rear section that will need to be removed to provide clearance for the rack and pinion. The front section of the crossmember re- mains in place to support the radiator.

2002 Chevy/GMC 3500-series Dual Underpro Speaker Installation Guide

This document provides all the necessary information to allow your Whelen product to be properly and safely installed. Before beginning the installation and/or operation of your new product, the installation technician and operator must read this manual completely. Important information is contained herein that could prevent serious injury or damage.