67-72 C-10 Truck Sport Sway Bar Kit 22108 Instructions

Raising Vehicle
Raise front of the vehicle by using a 4 post lift or drive-on ramps. Securely block the rear wheels of the vehicle. Do not remove the front wheels during installation. It is imperative that the vehicle is at ride height for this installation.
Install Frame Mounts
First step is to install the frame mounts. The mounts utilize existing rivet holes in the frame. You will need to air chisel the rivets as shown below. Once the holes are clear, grab the 3/8” x 1.5” hex bolts & washers from the “front” hardware bag and insert them into the rivet holes facing down. Position the mounting bracket to the frame rail and begin fastening the 3/8” bolts with the provided washers and nylock nuts. Do not tighten all the way! Grab the 3/8” x 1.25” hex bolts and drop them into the mount holes on the bracket itself. Don’t forget to use washers. You can now fully tighten the frame bolts at this time.
Install Bushings & Brackets
Next grease the inner surface of the provided polyurethane bushings and install them onto the sway bar near to the bends. Slide the bushing brackets onto the bushings as shown below.
Mount Bar onto Truck
Position the sway bar up to the frame mounts. Using the 3/8” hardware from the kit, start fastening the bushing brackets onto the frame mounts. Do not fully tighten these yet.
Install End Links
The front lower a-arms have an existing hole that the sway bar end links will utilize. First open up the 25108 end link kit. Grab the long bolt along with a large washer and bushing. Insert the bolt/washer/bushing into the sway bar hole from the top.

Source