2005-2007 Ford Five Hundred OBE Installation Guide 1.9

Tools Required for OBE Installation in Vehicle
Slotted screwdriver
Ratchet and metric sockets
STEP 1: Remove the speedometer dash trim and instrument cluster.
STEP 2: Wipe the area where the antenna will be installed with the alcohol wipe provided in the installation kit.
STEP 3: Wipe the back of the antenna with the alcohol wipe (non-text side). The top side of the antenna reads “TX/RX Side” for the rectangular antenna. Some installation kits will have a round antenna. The round antenna also has a logo on the top side. The text/logo side of the antenna should be installed in the “up” position and never taped against the vehicle.
STEP 4: Install the double sided tape on the antenna (non-text side).
STEP 5: Install the antenna.
When possible, point the front of the antenna to the front end of the car with the antenna cables pointing to the rear of the car.
Be sure the logo on top of the antenna is installed facing towards the windshield.
Do not install the antenna under any metal plates as this will interfere with reception. The antenna should only be installed under plastic.
Always install on top of a flat surface. Never install under a panel upside down. The double sided tape will not hold the antenna in place.
STEP 6: Remove the center console and set aside.
Pull the SkyWay antenna wires to the area where the OBE will be installed. See OBE Installation Overview diagram. Secure the antenna wires away from the radio wires and any moving parts such as the steering column with tie wraps.

Source