HID Kit Xenon Installation Instructions

The Chemical gases, most of which are xenon and iodides, are filled the quartz tube of the light. Through the ballast, then the voltage of 12V DC will be increased to 23KV immediately: the electrons of the xenon in the tube will be dissociated because of the voltage swing and thus an electrical arc happens between the two poles. Xenon light is power saving, safe and has long life, high luminance. In addition of the use of the UV-cut quartz tube, the light is crystal forever.
Installation instruction
1. Turn off the switch, open the lid of the engine after the engin gets cool, install the same type of HID bulbs in the discharg light group to take the place of the original halogen bubls and then plug all wire cables attached into the socket and ballast related. It is prohibited to touch the surface of HID bulb by hand. If it is dirty, it should be cleaned with the rag.
2. Changing the fuse in the electric circuit of the car into the fuse special for HID.
3. Beforeinstallation, check if the bulb can touch the inner cover of the light or the opening is too small. If so, install after proper adjustment.
4. Put the bulb into the light cover carefully with no damaging force, and then stabilize it and put the waterproof ring to the original.
5. After installation is over, connect the bulb with the ballast.
6. Fix the ballast in the proper place (careful for 3M double-face glue is very sticky)
7. Connect high-voltage wire with the bulb. Connect the input wires of the ballast with the socket of the light, and fix the ballast carefully. (Keep in mind: Must be far away from high temperature and the place in bad heat dispel), all the ex-factory car light HID be put under the headlight.
8. Check if the bulb is fixed and the cables between the bulb and the ballast is fastened.
9. Plug the wires from the voltage ballast into the electric circuit of the engine.

Source